<< previous page next page >>

Center for Engineering Design and Entrepreneurship

Policies and Procedures
Model Shop Safety Rules


Sander Safety



If an angle finish is desired both the belt and disk sanders table can be adjusted to an angle.

There is a handle on the right side of the belt sander, and knobs on both sides of the disk sander. Make sure that the table is secure before operating the sanders.
 
Handle adjustment on the right side of the belt sander. Use this to adjust angle on the belt table. Knob adjustment on either side of the disk sander. Use this to adjust angle on the disk table.


 

<< previous page next page >>